ULTIMATE MAINTENANCE
INSTRUCTIONS
HOW TO USE
D/A / ROTARY
- Apply 6-8 drops of MetalliCut to a firm foam polishing pad.
- Spread on the surface at speed 1-2.
- Increase speed to 4-5 to perform the cutting action until abrasives are broken down and high gloss is achieved.
- Using a clean MF towel remove buff any excess residue and repeat steps 1-3 as necessary.
MANUAL
- Apply a small amount of MetalliCut to a MF towel or wire wool depending on the metal type.
- Using medium to firm pressure work into the metal surface until the product becomes less opaque.
- Use a clean MF to buff away any residue to a high shine.
- Repeat steps 1-3 as necessary.
KEY FEATURES
- Fast effective cutting actionCan be used by hand or machineHigh gloss finishSafe on soft metals
Your Dynamic Snippet will be displayed here...
This message is displayed because youy did not provide both a filter and a template to use.
INSTRUCTIONS
HOW TO USE
- Apply to contaminated areas.
- Wait 5-6 min for full reaction. Agitate if needed.
- Rinse thoroughly with water. Avoid drying under direct sun.
KEY FEATURES
- Longer adhesion
- Powerful Iron Filings & Contaminants Cleaner
- Very economical.